A Revolution in Education
Hi there. A colleague is using a SmartBoard, that when clicked to orient on the target, a double click results. A message is then given that there was a click outside of the targeted area and to try again. And the cycle repeats - single click in target resulting in a double click.
Can anyone provide any insight? Does this even make sense?
Thanks very much!
I too have experienced this in my teachers classrooms. It seems that after installing, 11, the SmartBoards are more sensitive to touch. We have found that the key is when calibrating, make your your clothing does not touch the board, and that you do a quick tap on each x. I hope this helps.
I have also seen this if the SMART Board is shortening out or the drivers aren't quite working right. Updating firmware of the SMART Board and/or reinstalling the software has fixed this for me.